Updating d600 firmware

If no voltage is present, a solid-state switch may be in the “off” position and needs activating.

Connect the voltmeter to the outer terminals, take a 100-Ohm resistor (other values may also work), tie one end to ground and with the other end touch each terminal while observing the voltmeter.

The connections are often unmarked; however, the positive and negative are commonly located at the outer edges of the connector and the inner contacts accommodate the clock and data.

(The one-wire system combines clock and data.) For safety reasons, a separate thermistor wire is brought to the outside.

updating d600 firmware-45updating d600 firmware-44updating d600 firmware-59updating d600 firmware-47

Warming the battery with your hand is sufficient to detect a small change in resistor value when looking for the correct terminal on the battery.

Figure 1 illustrates a battery with six connections.

Some batteries are equipped with a solid-state switch that is normally in the “off” position and no voltage is present at the battery terminals.

If you have a suggestion or would like to report an error, please use the "contact us" form or email us at: Battery [email protected]

We like to hear from you but we cannot answer all inquiries.

Leave a Reply